Unknown drive shaft

Mercury Outboard  general discussion

Unknown drive shaft

Postby AU52N » Thu Feb 21, 2019 1:03 am

In one of our purchases we obtained a bunch of H length drive shaft but along with them were a few others and I have able to ID most.  One in particular I can not.  It is 23.25 inches long from end to end, the crank end has 6 splines and the pinion end has 8 splines.  The main shaft is 0.561" diameter.  The area where a ball bearing and seal would be is 0.5965" and below that were a roller bearing would ride it is 0.6895".  I also found a pinion gear that fits.  Any thoughts on what the shaft is used for.  Pictures attached to help.

Thanks


IMG_3018.JPG
bearing area
IMG_3019.JPG
Pinion end
IMG_3020.JPG
Crank end
AU52N
 
4 years of membership4 years of membership4 years of membership4 years of membership
 
Posts: 800
Images: 0
Joined: Sun Nov 01, 2015 3:26 pm

Re: Unknown drive shaft

Postby Marcus78n » Fri Feb 22, 2019 10:13 pm

David, this is a KG7 driveshaft .

Marcus
Marcus78n
 
1 year of membership
 
Posts: 34
Joined: Sat Feb 10, 2018 7:13 pm
Location: Honeoye, New York. 30 miles south of Rochester.


Return to John's Old Merc "General Forum"

Who is online

Users browsing this forum: No registered users and 1 guest